LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1992 >> Metro Base, 4D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (1.0L 3-CYL - VIN [5] & 1.0L 3-CYL Turbo - VIN [2]) >> Overhaul >> Fitting Pistons & Rings >> Installation

Fitting Pistons & Rings: Installation

WARNING: This page is about a different car, the 1988 Chevrolet Sprint. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install piston rings with "R" or "T" mark facing upward. Position ring gaps. See Fig 1. Apply engine oil to pistons, rings, cylinder walls, connecting rod bearings and crankpins. Install a piece of hose over connecting rod bolt threads.
  2. Using Piston Ring Compressor (J-8037), compress rings. Position piston with arrow facing crankshaft pulley. Using a hammer handle, tap piston head to install piston into cylinder.
Fig 1: Positioning Piston Ring End Gaps
G80628Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals