LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1991 >> Prizm Base, 4D Hatchback, Standard >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - A-240E/L, A-244L & A-245E >> Component Disassembly & Reassembly >> Direct Clutch >> Inspection

Direct Clutch: Inspection

  1. Clean all parts (except discs) with solvent. Dry parts using compressed air. Ensure check ball is free in piston. Apply low air pressure to small hole in piston to check for air leakage around piston valve. Inspect discs and plates for wear or burnt areas. If disc lining is peeled or discolored, replace discs as necessary. Replace all damaged components as necessary.
    NOTE: New discs must be soaked in ATF for at least 15 minutes prior to reassembly.
  2. Measure inside diameter of direct clutch bushing. Maximum inside diameter is 1.853" (47.07 mm). If inside diameter exceeds specification, replace direct clutch.
scientia non olet · About LEMON Manuals