LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1991 >> Prizm Base, 4D Hatchback, Standard >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis - A-240 "E" Series >> Removal & Installation >> Neutral Start Switch >> Installation

Neutral Start Switch: Installation

  1. Install neutral start switch on control shaft. Loosely install neutral start switch retaining bolts. Install seal and lock washer. Install lock nut and tighten to specification. See TORQUE SPECIFICATIONS  . Bend tabs on lock washer over against lock nut.
  2. Switch must be adjusted. Ensure parking brake is applied. Temporarily install manual lever on control shaft. Place shift lever in Neutral. Remove manual lever.
  3. Rotate neutral start switch and align reference mark on neutral start switch with groove. See Figure . Hold neutral switch in this position. Tighten retaining bolts to specification. To install remaining components, reverse removal procedure.
Fig 1: Removing & Installing Neutral Start Switch (1 of 2)
G93J24298Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Neutral Start Switch (2 of 2)
G93A24299Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals