All Except Paseo

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1992 Toyota Tercel, 1992 Toyota Supra, 1992 Toyota Paseo, 1992 Toyota MR2, and 1992 Toyota Cressida. However, it is still accessible from the selected car via links, so may be relevant.

Remove air cleaner. Check throttle cable bracket and linkage for looseness or bending. Depress accelerator to wide open throttle position.
Adjust cable housing so distance between rubber boot end and inner cable stopper or paint mark is .04" (1 mm). See Fig 1. Tighten lock nut.
For new throttle cables, stopper or paint mark will not be in place. With new cable securely installed in transmission, pull inner cable slightly until resistance is felt. See Fig 2. Stake new stopper or paint a mark as shown.

Fig 1: Adjusting Throttle Cable (Except Paseo)

Fig 2: Marking New Throttle Cable (Except Paseo)