Removal & Installation (Previa)
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 1992 Toyota Tercel, 1992 Toyota Supra, 1992 Toyota Previa, 1992 Toyota Paseo, and 1992 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Remove ATF level gauge. Remove throttle cable clamp and disconnect throttle. Raise vehicle. Remove filler tube. On 4WD, remove front drive shaft.
- On both models, remove shift control cables. On 2WD, remove starter. On 4WD, remove starter and front drive shaft bracket. On 2WD, remove stiffener plates. On both models, remove torque converter bolts.
- Remove oil cooler tubes. Remove exhaust pipe bracket. On 2WD, remove drive shaft. On 4WD, remove rear drive shaft. Jack up transmission. Remove rear engine mount bolts.
- Remove the remaining transmission retaining bolts and pull out the transmission. To install, reverse removal procedure. Torque converter is properly installed when 1.250" (31.75 mm) of space exists between the torque converter drive lugs and front surface of bellhousing. See Figure. Tighten the torque converter bolts to specification. Refer to the TORQUE SPECIFICATIONS table.