PRIZM (EXCEPT GSi): Installation
WARNING: This page is about a different car, the 1992 Geo Tracker and 1992 Geo Prizm. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Before installing, apply grease around cup at center of torque converter.
- Ensure torque converter is correctly installed. Distance from torque converter drive lugs to engine mating surface of transaxle housing should be at least .79" (20 mm).
- Tighten all fasteners to specification. See TORQUE SPECIFICATIONS . Adjust all control cables. Fill and check fluid levels.