All Models
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1991 Toyota Tercel, 1991 Toyota Supra, 1991 Toyota MR2, 1991 Toyota Cressida, and 1991 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- Remove air cleaner. Check throttle cable bracket and linkage for looseness or bending. Depress accelerator to wide open throttle position.
- Adjust cable housing so distance between rubber boot end and inner cable stopper or paint mark is .04" (1.0 mm). See Fig 1. Tighten lock nut.
- For new throttle cables, stopper or paint mark will not be in place. With new cable securely installed in transmission, pull inner cable slightly until resistance is felt. See Fig 2. Stake new stopper or paint a mark as shown.