Code 22, Coolant Temp Sensor/Open Or Short Circuit

The Coolant Temperature Sensor (CTS) uses a thermistor to control signal voltage to ECM. ECM applies voltage on White wire to the sensor. When engine is cold, thermistor resistance is high. ECM will sense high signal voltage.

As engine warms, thermistor resistance decreases. ECM will sense low signal voltage. When engine reaches normal operating temperature, signal voltage will be approximately 1.5-2.0 volts at ECM.

1. Verifies 4-5 volts is present at CTS connector.
2. Checks ground side of CTS circuit.
3. Determines if problem is caused by ECM or open Brown wire. Ensure ECM connectors fit properly.
4. Determines whether problem is in circuit or ECM. Ensure ECM connectors fit properly.