Removal (Metro)
- Raise and support vehicle. Remove wheel. Straighten staked part of drive axle nut. With brake pedal applied, remove drive axle nut and loosen hub-to-rotor bolts.
- Discard drive axle nut. Remove caliper. Using wire, support caliper from frame. Remove washer from end of drive axle. Measure distance between outside rotor face and outside edge of caliper support bracket. See Fig 1.
- Record dimension "A" for installation reference. Using slide hammer and adapter, remove axle hub and rotor as an assembly. Remove hub-to-rotor bolts from hub, and separate hub from rotor.
Courtesy of GENERAL MOTORS CORP.