LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1991 >> Prizm Base, 4D Hatchback, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Testing >> Combination Switch Testing >> Turn Signal Switch (Metro)

Turn Signal Switch (Metro)

  1. Disconnect switch harness connectors from junction/fuse block located under left lower dash panel. See Figure . Move turn signal stalk to left-turn position.
  2. Check for continuity between Green wire and Green/Red wire terminals of 5-wire switch connector. If continuity is not present, replace combination switch assembly. If continuity exists, go to next step.
  3. Move turn signal stalk to right-turn position. Check for continuity between Green wire and Green/Yellow wire terminals of 5-wire switch connector. If continuity is not present, replace combination switch assembly.
scientia non olet · About LEMON Manuals