Removal & Installation (Lock Cylinder - Prizm)

1. Disconnect negative battery cable. Remove lower dash trim cover and both steering column covers. See Fig 1 . Disconnect ignition switch harness connector from behind instrument panel, near steering column. Remove steering column mounting bolts and lower column.
2. Install key and turn ignition switch to ACC position. Using small punch, push down lock pin and pull lock set from housing. See Fig 3 . To install, reverse removal procedure.

Fig 1: Exploded View of Steering Column (Prizm)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Exploded View of Ignition Switch & Lock Cylinder (Prizm)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing Ignition Lock Cylinder (Prizm)

Courtesy of GENERAL MOTORS CORP.

WARNING: Before proceeding, see AIR BAG PRECAUTIONS  at beginning of article.