Removal (Prizm & Prizm GSi)

Remove pinch bolt from steering column yoke at steering gear. Raise and support vehicle. Remove front wheels.
NOTE: Remove crossmembers below engine and transaxle for steering gear removal. Center crossmember is connected at radiator support and main crossmember. The main crossmember is attached to the body.
Using Engine Support Fixture (J-287467-A), support engine. Remove necessary mount bolts for crossmember removal. Support the main crossmember. Remove main crossmember-to-center crossmember bolts.
Remove center crossmember-to-radiator support bolts. Remove main crossmember-to-body bolts. Remove lower A-frame bracket-to-body bolts.
Lower main crossmember while holding center crossmember. Remove both crossmembers. Remove tie rod-to-steering knuckle retaining nuts. Separate tie rods from steering knuckles.
Using Wrench (J-29698-A), disconnect pressure and return lines at steering gear. Plug all lines and openings. Remove steering gear mounting bolts and brackets. Remove steering gear from right side of vehicle.