LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1991 >> Prizm Base, 4D Hatchback, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VINS [5,6] >> Removal & Installation >> Rear Crankshaft Oil Seal >> Installation

Rear Crankshaft Oil Seal: Installation

  1. Ensure all sealing surfaces are clean. Using Seal Installer (J-35388), install seal in seal retainer. Lubricate seal lip with grease.
  2. On Prizm, install seal retainer using new gasket. On Prizm GSi, apply Sealant (1052942) on seal retainer-to-cylinder block surfaces and install seal retainer.
  3. On all models, tighten bolts to specification. See TORQUE SPECIFICATIONS table at end of article. To install remaining components, reverse removal procedure. Ensure reference mark on flywheel/drive plate aligns with mark on crankshaft.
scientia non olet · About LEMON Manuals