LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1991 >> Metro XFi >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (1.3L 4-CYL - VINS [3,5] & 1.6L 4-CYL - VIN [0]) >> Removal & Installation >> Valve Clearance Adjustment

Valve Clearance Adjustment

WARNING: This page is about a different car, the 1989 Suzuki Swift, 1989 Suzuki Sidekick, and 1989 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Swift DOHC engines has automatic valve lash adjusters. No adjustment is required.
  1. Ensure engine has reached normal operating temperature. Place No. 1 piston at TDC position. Remove distributor cap. Ensure rotor is pointing toward No. 1 distributor terminal.
  2. If rotor is not correctly positioned, rotate crankshaft clockwise 360 degrees until No. 1 piston is at TDC of compression stroke. Remove rocker arm cover.
  3. Loosen adjustment screw lock nut. Adjust intake and exhaust valves of No. 1 cylinder, intake valve of No. 2 cylinder and exhaust valve of No. 3 cylinder. Rotate crankshaft 360 degrees clockwise.
  4. Adjust intake valves of cylinder No. 3 and cylinder No. 4. Adjust exhaust valves of cylinder No. 2 and cylinder No. 4. Tighten adjusting screw lock nuts. Install rocker arm cover.
VALVE CLEARANCE SPECIFICATIONS

Valve Hot In. (mm) Cold In. (mm)
Exhaust .011 (.27) .007 (.18)
Intake .005-.006 (.13-.17) .009-.011 (.23-.27)
scientia non olet · About LEMON Manuals