LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1991 >> Metro XFi >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (1.3L 4-CYL - VINS [3,5] & 1.6L 4-CYL - VIN [0]) >> Removal & Installation >> Camshaft & Sprockets (Swift DOHC) >> Installation

Camshaft & Sprockets (Swift DOHC): Installation

WARNING: This page is about a different car, the 1989 Suzuki Swift, 1989 Suzuki Sidekick, and 1989 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate camshaft lobes and camshaft bearing journals. Install camshaft in cylinder head. Install camshaft bearing caps and tighten in sequence (if equipped). See Fig 2 . Install camshaft sprocket.
  2. Ensure that camshaft sprocket mark is aligned with timing mark on cylinder head. See Figure and Figure . Reverse removal procedure to complete installation.
Fig 1: Installing Camshaft Sprocket
G81630Courtesy of SUZUKI OF AMERICA CORP.
Fig 2: Camshaft Bearing Cap Bolt Tightening Sequence (DOHC)
G90E00343Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals