LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1991 >> Metro XFi >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (1.3L 4-CYL - VINS [3,5] & 1.6L 4-CYL - VIN [0]) >> Overhaul >> Thrust Bearing

Thrust Bearing

WARNING: This page is about a different car, the 1989 Suzuki Swift, 1989 Suzuki Sidekick, and 1989 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
  1. With crankshaft bearing caps installed, check thrust clearance (end play) by inserting feeler gauge between center main bearing and crankshaft thrust face.
  2. Standard thickness of thrust bearing is .0984" (2.50 mm). Oversize thrust bearings are available in increments of .0049" (.125 mm). If clearance exceeds specification, replace thrust bearing.
scientia non olet · About LEMON Manuals