Cylinder Block Specifications

WARNING: This page is about a different car, the 1989 Suzuki Swift, 1989 Suzuki Sidekick, and 1989 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.

CYLINDER BLOCK SPECIFICATIONS

Application

In. (mm)

Maximum Block Warp ⁽¹⁾

.006 (.15)

Cylinder Bore

Standard Diameter

1.3L ⁽²⁾

2.9138-2.9142 (74.01-74.02)

1.6L ⁽³⁾

2.9531-2.9535 (75.01-75.02)

Maximum Taper

.0039 (.100)

Maximum Out-of-Round

.0039 (.100)

⁽¹⁾	Surface may be machined a maximum of .008" (.20 mm) from original surface.

⁽²⁾	Cylinder block is stamped with cylinder bore diameter I.D. numbers. Specification is for I.D. No. 1. I.D. No. 2 is 2.9134-2.9138" (74.00-74.01 mm). See Text and Figure .

⁽³⁾	Cylinder block is stamped with cylinder bore diameter I.D. numbers. Specification is for I.D. No. 1. I.D. No. 2 is 2.9528-2.9531" (75.00-75.01 mm). See text and Figure .