Steering Wheel & Horn Pad: Installation

1. Connect horn wire from steering wheel to contact plate. Install contact plate and rear cover to steering wheel. Coat steering wheel slip ring contact surfaces with dielectric grease. Align reference marks made during removal. Install steering wheel and retaining nut on shaft.
2. Tighten retaining nut to specification. See TORQUE SPECIFICATIONS table. Install horn button/center pad assembly to steering wheel contact plate.

Fig 1: Removing Typical Steering Wheel

Courtesy of GENERAL MOTORS CORP.

Fig 2: Exploded View of Steering Column Assembly

Courtesy of GENERAL MOTORS CORP.