LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1990 >> Tracker Base, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Testing >> Temperature Gauge & Sending Unit >> Gauge Check

Gauge Check

  1. Disconnect Yellow/White wire connector at temperature gauge sending unit on intake manifold. Connect test light between wire connector and ground. Turn ignition on. Test light should light dimly and gauge pointer should fluctuate toward hot.
  2. If gauge pointer is inactive, remove instrument cluster. See INSTRUMENT CLUSTER  . Connect ohmmeter leads across temperature gauge terminals on back of instrument cluster. See Fig 1 . Resistance reading should be 60 ohms. If resistance is not as specified, replace temperature gauge.
Fig 1: Testing Coolant Temperature Gauge Resistance (Metro - Tracker Similar)
G91F01813Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals