LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1990 >> Metro LSi, 2D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (1.3L 4-CYL - VIN [3] & 1.6L 4-CYL - VIN [0]) >> Removal & Installation >> Water Pump >> Removal

Water Pump: Removal

WARNING: This page is about a different car, the 1992 Suzuki Swift, 1992 Suzuki Sidekick, and 1992 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system. Disconnect negative battery cable. Remove drive belts. Discharge A/C system using approved refrigerant recovery/recycling equipment and disconnect compressor flexible suction hose from suction pipe (if equipped). On Samurai and Sidekick, remove cooling fan, fan shroud and fan clutch.
  2. On all models, remove pump pulley. Ensure No. 1 piston is at TDC of compression stroke. Remove crankshaft pulley bolts and crankshaft pulley. Remove timing belt cover. See TIMING BELT  under REMOVAL & INSTALLATION. Remove dipstick and tube. Remove alternator mounting bracket. Remove water pump.