LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1990 >> Metro LSi, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (1.0L 3-CYL - VIN [5] & 1.0L 3-CYL Turbo - VIN [2]) >> Removal & Installation >> Cylinder Head >> Removal

Cylinder Head: Removal

WARNING: This page is about a different car, the 1987 Chevrolet Sprint. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable and drain coolant. Remove air cleaner. On EFI Turbo models remove intercooler, pipes and hoses to airflow meter.
  2. Remove rocker arm cover and distributor. Remove throttle control cable, emission control hoses, coolant hoses and electrical connectors to engine.
  3. On EFI models, depressurize fuel system before removing fuel hoses. Remove brake booster vacuum hose. Remove crankshaft pulley, outer timing belt cover, timing belt and tensioner. Disconnect O2 sensor lead. Remove exhaust pipe at manifold and secondary air valve.
  4. Remove fuel pump and rocker shaft assemblies. Remove engine side mount at cylinder head. Loosen and remove cylinder head bolts. Remove cylinder head and manifolds as an assembly.
scientia non olet · About LEMON Manuals