LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1990 >> Metro Base, 4D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (1.0L 3-CYL - VIN [5] & 1.0L 3-CYL Turbo - VIN [2]) >> Overhaul >> Front Oil Seal >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 1988 Chevrolet Sprint. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove oil pump from block. Disassemble oil pump. Remove front oil pump seal. Install new seal on pump. Install 2 alignment pins and oil pump gasket on block. Position Oil Seal Guide (J-34853) onto crankshaft and lubricate outside of guide with oil.
  2. Install oil pump assembly. Tighten mounting bolts to specifications. Check seal to ensure seal lip is not turned up. Remove guide. Trim gasket even with oil pump and oil pan mounting face on block.
scientia non olet · About LEMON Manuals