Repair Procedures: Inspection: Notes

WARNING:

Warning and guide sounds regarding engine start and driving are generated through the external amplifier. (Hazard lamp, seat belt warning, turn signal, HDA Hand OFF, LKAS, RCTA, etc.)
When the external amplifier or speakers are replaced with other products, a failure may occur in the amplifier and warning and guide sounds (excluding the ETCS guide sound) may not be generated.
Virtual engine sound inside the vehicle (occurs in Sport mode) is generated by the external amplifier. Therefore, if the external amplifier or speakers are replaced with other products, a failure may occur in the amplifier and virtual engine sound may not be generated properly.

Check point (Warning indicator)

NOTE: Fault conditions and normal operating conditions, refer to the owner's manual.

No	Ref Symbol	Name	Color	Signal Input	Signal Control	Check Point
1	Courtesy of HYUNDAI MOTOR AMERICA	Turn signal (Left)	Green	CAN	IGPM (Gateway)	Multifunction switch IBU IGPM CAN failure
2	Courtesy of HYUNDAI MOTOR AMERICA	Turn signal (Right)	Green	CAN	IGPM (Gateway)	Multifunction switch IBU IGPM CAN failure
3	Courtesy of HYUNDAI MOTOR AMERICA	Tail Lamp	Green	CAN	IGPM (Gateway)	Multifunction switch IBU IGPM CAN failure
4	Courtesy of HYUNDAI MOTOR AMERICA	Low Beam	Green	CAN	IGPM (Gateway)	Multifunction switch IBU IGPM CAN failure
5	Courtesy of HYUNDAI MOTOR AMERICA	HBA	Green	CAN	LKAS	LKAS System CAN failure
6	Courtesy of HYUNDAI MOTOR AMERICA	Rear Fog Lamp	Yellow	CAN	IGPM (Gateway)	Multifunction Switch IBU IGPM CAN Failure
7	Courtesy of HYUNDAI MOTOR AMERICA	High Beam	Blue	CAN	IGPM (Gateway)	Multifunction switch IBU IGPM CAN failure
8	Courtesy of HYUNDAI MOTOR AMERICA	Warning	Yellow	CAN + Hard-wired	BSD	BSD System CAN failure
					PSB	PSB System IGPM CAN failure
					SCC ECS	SCC System AEB System LDWS System AHLS System TPMS System HSWS System
					Low Washer	Washer fluid lever sensor Wiring failure
					Digital Input	Reminders when service checks
9	Courtesy of HYUNDAI MOTOR AMERICA	Battery Charge	Red	Hard-wired	Alternator	Alternator Wiring Failure Battery
10	Courtesy of HYUNDAI MOTOR AMERICA	Oil Pressure	Red	Hard-wired	ECM	Oil pressure sensor Wiring Failure ECM CAN failure
11	Courtesy of HYUNDAI MOTOR AMERICA	Check Engine	Yellow	CAN	ECM	ECM CAN failure
12	Courtesy of HYUNDAI MOTOR AMERICA	Immobilizer	Yellow	CAN + Hard-wired	IGPM (Gateway)	SMK System IGPM CAN failure Hard-wired
13	Courtesy of HYUNDAI MOTOR AMERICA	Parking Brake Brake Fluid EBD EPB EVP	Red	CAN	IGPM (Gateway) EBD EPB	IGPM VDC System EPB System CAN failure Parking Brake Switch Brake Oil lever sensor
14	Courtesy of HYUNDAI MOTOR AMERICA	ABS	Yellow	CAN	ABS	TCS System CAN failure
15	Courtesy of HYUNDAI MOTOR AMERICA	ESC	Yellow	CAN	TCS	TCS System CAN failure
16	Courtesy of HYUNDAI MOTOR AMERICA	ESC Off	Yellow	CAN	TCS	TCS System CAN failure
17	Courtesy of HYUNDAI MOTOR AMERICA	EPB	Yellow	CAN	EPB	EPB System CAN failure
18	Courtesy of HYUNDAI MOTOR AMERICA	LED Head lamp	Yellow	CAN	AFLS	AFLS System CAN failure
19	Courtesy of HYUNDAI MOTOR AMERICA	AFS System	Yellow	CAN	AFLS	AFLS System CAN failure
20	Courtesy of HYUNDAI MOTOR AMERICA	Seat Belt	Red	CAN	IGPM (Gateway)	IGPM CAN failure
21	Courtesy of HYUNDAI MOTOR AMERICA	Airbag	Red	CAN	SRSCM	SRSCM System CAN failure
22	Courtesy of HYUNDAI MOTOR AMERICA	EPS (MDPS)	Red	CAN	MDPS	MDPS Unit system MDPS Motor CAN failure
23	Courtesy of HYUNDAI MOTOR AMERICA	TPMS	Yellow	CAN	TPMS	TPMS System TPMS sensor CAN failure
24	Courtesy of HYUNDAI MOTOR AMERICA	4WD	Yellow	CAN	4WD	4WD ECU CAN failure
25	Courtesy of HYUNDAI MOTOR AMERICA	Fuel Warning	Yellow	Direct (Micom)	Fuel Segment	Fuel Segment Failure Wiring Failure
26	Courtesy of HYUNDAI MOTOR AMERICA	FCA	Yellow	CAN	AEB	SCC System CAN failure
27	Courtesy of HYUNDAI MOTOR AMERICA	Diesel Particulate Filter (GPF)	Yellow	CAN	ECM	GPF System CAN Failure
28	Courtesy of HYUNDAI MOTOR AMERICA	Gasoline Particulate Filter (GPF)	Yellow	CAN	ECM	GPF System CAN Failure
29	Courtesy of HYUNDAI MOTOR AMERICA	Preheating plug warning	Yellow	CAN	EMS	CAN Failure

Check point (Gauge)

No	Name	Signal Input	Signal Control (Unit/Sensor)	Check Point
1	Speedometer	C-CAN	TCU	CAN Line failure
2	Tachometer	C-CAN	ECM	CAN Line failure
3	Cooling water temperature	C-CAN	ECM	CAN Line failure
4	Fuel	Hardwire	Fuel Sander	Fuel sender failure
4	Fuel	Hardwire	Fuel Sander	Wiring failure

Other cluster check list
1. USM (User Setting Mode)
  USM setting process
  
  Setting can be changed by using the buttons of the steering switch. The items include In/out Seat Synchronization, Auto Door Lock, Auto Door Lock Deactivate, Head Lamp Escort, Welcome Light, Welcome Sound, Triple Turn Signal, Average Fuel Consumption Auto Reset, HUD Height Adjustment, Brightness, and Content Setup. These items can be set and changed.