SS-A Solenoid Valve (ON/OFF): Installation
- To install, reverse the removal procedures.
- Inject automatic transmission fluid.
Refer to Hydraulic system - "FLUID ")
- Clear the diagnostic trouble codes (DTC) using the diagnostic tool.CAUTION:
- Even though disconnecting the battery negative terminal, the DTCs will not be cleared. So, be sure to clear the DTCs using the diagnostic tool.
- In order to prevent start delay and gear shift shock during acceleration and start, perform TCM learning after replacing the transmission, TCM, and solenoid valve.
(Refer to Automatic Transmission Control System - "ADJUSTMENT ")
CAUTION:
- After inspecting and replacing the oil level, make sure to remove all the transmission oil in the outside of the automatic transmission (In particular, remove the residual transmission oil between the transmission case and oil pan) sure to remove the transmission oil of the automatic transmission's outside.