Console Temperature Control Actuator: Inspection

Turn the ignition switch OFF.
Disconnect the console temperature control actuator and console ON/OFF actuator connector.

Verify that the console temperature actuator and console ON/OFF actuator operates to the cool position when connecting 12V to terminal 7 and grounding terminal 3.

Verify that the temperature control actuator operates to the warm position when connected in reverse.

Courtesy of HYUNDAI MOTOR AMERICA

Console temperature actuator

Terminal	Function
1	-
2	-
3	Warm position
4	Sensor ground
5	Feedback signal
6	Sensor power (+5V)
7	Cool position (Console OFF)

Console temperature actuator A

Terminal	Function
1	-
2	-
3	Warm position
4	Sensor ground
5	Feedback signal
6	Sensor power (+5V)
7	Cool position

Console ON/OFF actuator

Terminal	Function
1	-
2	-
3	Console (OFF)
4	Sensor ground
5	Feedback signal
6	Sensor power (+5V)
7	Cool position (Console ON)

Connect the console temperature control actuator and console ON/OFF actuator connector.
Turn the ignition switch ON.
Check the voltage between terminal 4 and 5.
If the measured voltage is not within specification, substitute with a known-good console temperature actuator and console ON/OFF actuator and then check for proper operation.
Replace the console temperature actuator and console ON/OFF actuator if it is proved that there is a problem with it.