Engine coolant reservoir tank

WARNING: This page is about a different variant/trim than selected.

Loosen the drain plug and drain the engine coolant.
(Refer to Cooling System - "COOLANT ")
Remove the engine coolant reservoir tank.
1. Disconnect the reservoir tank water hose (A).
2. Disconnect the digassing hose (B).
3. Remove the reservoir tank (C).
  Tightening torque:
  
  7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.7 - 8.6 Ib.ft)
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Fill the engine coolant.
(Refer to Cooling System - "COOLANT ")
NOTE:
- The engine coolant must be injected according to the integrated thermal management module (ITM) coolant filling method.