LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2024 >> GV70 2.5T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Fuel Delivery System - 3.5L) >> Fuel Sender Assembly >> Inspection >> [Fuel Pump Motor]

[Fuel Pump Motor]

WARNING: This page is about a different variant/trim than selected.
  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Remove the fuel pump assembly.

    (Refer to "REMOVAL AND INSTALLATION ")

  3. Connect the fuel pump connector.
  4. Connect the negative (-) battery terminal.
  5. Under no load state, turn the ignition switch ON or crank an engine to operate the fuel pump.
    CAUTION:
    • Cranking for a long time may cause the failure of the fuel pump due to overheat as engine is no load state. Thus, cranking should be performed within 3 seconds.
    • Fuel may spread to the vehicle side due to residual fuel when operating the fuel pump. So, make sure that the fuel feed line nipple faces the fuel tank.
scientia non olet · About LEMON Manuals