Brake Pedal: Adjustment: Notes

The brake pedal sensor calculates the pedal full stroke according to the preset zero. Therefore, zeroing adjustment is necessary when first installed. Calibration must be performed in the following cases.

After changing the brake pedal assembly (you cannot change only the sensor).
After changing the Integrated Electronic Booster (IEB).
When error codes C1380 (calibration) or C1379 (signal error) are detected.
After bleeding Integrated Electronic Booster (IEB).

NOTE:

The brake pedal sensor cannot be replaced as a single part and must be replaced with a brake pedal assembly.
When replacing or re-installing the brake pedal sensor alone, the braking performance may be adversely affected due to the stroke zero setting error.