Integrated Electronic Brake (IEB) System Air Bleeding Procedures: Notes
CAUTION:
- Do not reuse the drained fluid.
- Always use genuine DOT4 brake Fluid.
Using a non-genuine DOT4 brake fluid can cause corrosion and decrease the life of the system.
* Standard: SAE J1704 DOT-4 LV, ISO4925 LCASS-6, FMVSS 116 DOT-4
- Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
- Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
- The reservoir on the master cylinder must be at the MAX (upper) level mark at the start of bleeding procedure and checked after bleeding each brake caliper. Add fluid as required.