Inspection Guide 2

Monitor the lamp illumination, adjusting multifunction switch.
If software malfunctions, illuminate two low-beam module in upper side, regardless of multi-functional operation.
- Reset the power, if there the module software is malfunctioning.
  (Trunk battery - Remover the battery terminal wire, and reconnect it.)
If the internal memory element in controller is malfunctioning, turn off the lamp, regardless of multi-functional operation.
- If the memory element malfunctions, replace head lamp controller (ILCU) and go to the "Verification of Vehicle Repair".
If the software operates properly, the function that represents multi-functional operation result will illuminate.