LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2022 >> GV80 3.5T Advanced >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Crash Pad >> Glove Box Housing Cover >> Repair Procedures >> Replacement

Repair Procedures: Replacement

CAUTION:
  • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
  • Take care not to bend or scratch the trim and panels.
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Remove the floor console assembly.

    (Refer to Floor Console - "FLOOR CONSOLE ASSEMBLY ")

  2. Remove the crash pad lower panel.

    (Refer to Crash Pad - "CRASH PAD LOWER PANEL ")

  3. Remove the crash pad side cover [RH].

    (Refer to Crash Pad - "CRASH PAD SIDE COVER ")

  4. Loosen the mounting screw and then remove the crash pad garnish [RH] (A).
    G14723342Courtesy of HYUNDAI MOTOR AMERICA
  5. Separate the start button connector (A).
    G14723343Courtesy of HYUNDAI MOTOR AMERICA
  6. Loosen the mounting screws and nuts, remove the glove box housing cover (A).
    G14723344Courtesy of HYUNDAI MOTOR AMERICA
  7. Separate the glove box lamp connector (A).
    G14723345Courtesy of HYUNDAI MOTOR AMERICA
  8. Separate the glove box switch connector (A).
    G14723346Courtesy of HYUNDAI MOTOR AMERICA
  9. To install, reverse removal procedure.

    Information 

    • Replace any damaged clips (or pin-type retainers).
    • Make sure the connector are connected in properly.
scientia non olet · About LEMON Manuals