Crash Pad Center Panel (RH)

CAUTION:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on gloves to prevent hand injuries.
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the glove box housing cover.
(Refer to Crash Pad - "GLOVE BOX HOUSING COVER ")
Loosen the mounting screw, remove the crash pad center molding (A).

Courtesy of HYUNDAI MOTOR AMERICA
Press the lock pin, separate the crash pad mood lamp connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting screws and nut, remove the crash pad center panel garnish (A).

Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting screws and nut, remove the crash pad center panel [RH] (A).

Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse removal procedure.
Information
- Replace any damaged clips (or pin-type retainers).
- Make sure the connector are connected in properly.