Leakage from radiator
WARNING: This page is about a different variant/trim than selected.
- Wait until the engine cools down completely and then carefully open the reservoir tank cap. Fill radiator with coolant and then install the pressure tester.
- Raise the pressure of pressure tester to approximate 93.16 - 122.58 kpa (0.95 - 1.25 kg/cm2 , 13.51 - 17.78 psi).
- Check the coolant leakage and drop in pressure.
- Remove the pressure tester and then reinstall the radiator cap.NOTE:
- Check whether the engine oil is mixed with the coolant.