Check OCV
WARNING: This page is about a different variant/trim than selected.
- Connect GDS to Data Link Connector (DLC).
- Turn "ON" the ignition switch (Engine "OFF").
- Perform "Actuation Test" for OCV.
- Does the OCV work normally? (Check clicking sound)
YES
- Substitute with a known-good CVVT and check for proper operation. If the problem is corrected, replace CVVT and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good OCV and check for proper operation. If the problem is corrected, replace OCV and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.