Component Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn "OFF" the ignition.
- Disconnect the electrical thermostat connector.
- Measure the resistance between the power and control terminal of electrical thermostat. (Component side)
Specification:
Temperature Resistance 20 ± 5°C (68 ± 9°F) 11.2 ± 0.6 Ω - Is the measured resistance within specification?
YES
- Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good component and check for proper operation. If the problem is corrected, replace component and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.