Check open in harness
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect the A/C pressure sensor connector.
- IG "ON"
- Measure the voltage between power terminal of A/C pressure sensor harness connector and chassis ground. (Measurement "A")
- Measure the voltage between power and ground terminals of A/C pressure sensor harness connector. (Measurement "B")
Specification: The Difference between "A" and "B" is below 200 mV.
- Is the measured voltage within specification?
YES
- Go to "SIGNAL CIRCUIT INSPECTION " procedure.
NO
- Repair as necessary. go to "VERIFICATION OF VEHICLE REPAIR " procedure.