Check resistance of OCV
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect oil pump regulating valve connector.
- Measure resistance between power and signal terminals of oil pump regulating valve. (Component Side) Specification: 22.0 ~ 26.0 [20°C (68°F)]
- Is the measured resistance within specification?
YES
- Go to next step as below.
NO
- Substitute with a known - good oil pump regulating valve and check for proper operation. If the problem is corrected, replace oil pump regulating valve and go to "VERIFICATION OF VEHICLE REPAIR " procedure.