Check open in harness
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect stop lamp switch connector.
- Measure the resistance between brake switch signal terminal of ECM harness connector and brake switch signal terminal of Stop lamp switch harness connector.
- Measure the resistance between brake lamp signal terminal of ECM harness connector and brake lamp signal terminal of Stop lamp switch harness connector.
Specification: Below 1Ω
- Is the measured resistance within specification?
YES
- Go to "CHECK BATTERY VOLTAGE " procedure.
NO
- Repair open in circuit. go to "VERIFICATION OF VEHICLE REPAIR " procedure.