DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
Case 1 |
- Comparing 2 brake signals during driving
|
- Poor connection
- Open or short in Stop lamp switch
- Faulty Stop lamp switch
|
| Case 2 |
- ECM detects stop lamp input signal when vehicle stops
|
| Enable Conditions |
Case 1 |
- Engine running
- Vehicle Speed Sensor is abnormal.
- Engine running
- Vehicle Speed Sensor is normal and Vehicle Speed is over 20 kph (12.4 mph) during 1 sec or more.
|
| Case 2 |
- Engine running
- Vehicle Speed Sensor is normal and Vehicle Speed is over 20 kph (12.4 mph) during 1 sec or more.
|
| Threshold Value |
Case 1 |
- The one brake signal's change duration when another signal has been changed longer than 0.5 sec.
|
| Case 2 |
- Vehicle speed less than 3 kph (1.8 mph)
- Vehicle acceleration slower than -6 kph/s
- Stop lamp "OFF" and no change of the stop lamp signal for more 3
|
| Diagnosis Time |
|
| MIL On Condition |
|