Control Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Turn off the ignition switch.
Disconnected the ECM (ECM) connector.
Turn on the ignition switch.
Measure voltage between ignition switch terminal of ECM harness connector and chassis ground.
Specification: B+
Is the measured voltage within specification?
YES
- Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.