Check open in harness
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect ETC Motor & TPS connector and ECM connector.
- Measure the resistance between ETC motor (+) terminal of ETC Motor & TPS harness connector and ETC motor (+) terminal of ECM harness connector.
- Measure the resistance between ETC motor (-) terminal of ETC Motor & TPS harness connector and ETC motor (-) terminal of ECM harness connector.
Specification : Approx. below 1Ω
- Is the measured resistance within specification?
YES
- Go to "SYSTEM INSPECTION" procedure.
NO
- Repair open in motor harness. go to "VERIFICATION OF VEHICLE REPAIR " procedure.