DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
Case 1	DTC Strategy	TPS adaptation condition check	Throttle stuck Open in motor circuit Faulty motor Faulty ECM
	Enable Conditions	-
	Threshold Value	TPS adaptation is requested, but not possible
Case 2	DTC Strategy	ETC Limp Home position check
	Enable Conditions	During TPS adaptation
	Threshold Value	Difference between Throttle sensor voltage in limp home and limp home set point is greater than 0.332V
Case 3	DTC Strategy	Lower mechanical stop adaptation voltage range check
	Enable Conditions	During TPS adaptation
	Threshold Value	Difference between Throttle sensor voltage in lower mechanical stop position and lower mechanical stop set point position is greater than 0.322V
Diagnosis Time		1.2 seconds
MIL On Condition		1 driving cycle

If the Main relay is inoperable with engine running, the following DTCs can set.