LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Engine Control System Diagnosis - 3.3L (7 Of 9)) >> DTC P061B-00: Torque Control Signal Failure >> Wiring Inspection >> Terminal and connection Inspection

Terminal and connection Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ECM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
  2. Connect the GDS and go to "Current Data".
  3. Monitor ECM values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).
  4. Any change in the values indicates a poor connection. Was a connector problem found?

    YES 

    NO 

    • Substitute with a known-good ECM and check for proper operation. If the problem is corrected, replace ECM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals