LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Engine Control System Diagnosis - 3.3L (7 Of 9)) >> DTC P061A-00: Internal Control Module Torque Performance >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.
Item Detecting Condition Possible Cause
DTC Strategy
  • Level 2 monitoring (=Process monitoring)
  1. Poor connector connection
  2. Faulty ECM
Enable Conditions
  • Ignition "ON"
  • Engine speed during engine start is higher than 32 RPM
Threshold Value
  • Actual value is higher or lower than allowable range (ADC monitoring or Engine speed ratio monitor or Idle speed controller monitor or torque loss monitor or Min/Max Clutch torque monitor or Pedal value monitor or TPS ratio monitor or Mass fuel flow monitor errors)
Diagnostic Time
  • 480ms
MIL On Condition
  • 1 driving cycle