Control Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF" and Disconnect the Injector connectors.
- IG "ON".
- Measure voltage between Injector Highside control terminal of Injector harness connector and chassis ground.
Measure voltage between Injector Lowside control terminal of Injector harness connector and chassis ground.
Specification:
High: Approx. 11V
Low: Approx 0.2V
- Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.