DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible cause |
| DTC Strategy |
|
- EWGA
- Boost pressure sensor (PUT/2nd T-MAP)
- Turbo charger (turbine)
|
| Enable Conditions |
- Battery Voltage is between 10V and 16V
- Engine running (Engine speed is faster than 32 RPM)
- Difference between Manifold air pressure (MAP) and Barometric pressure (BARO) is greater than 0 kPa. (turbocharger operation "boosted)
|
| Threshold Value |
- Adaption value of natural boost pressure is out of range
- Natural boost pressure additive adaptation value is lower than -25 kPa
- Natural boost pressure additive adaptation value is higher than 25 kPa
- Waste gate actuator position adaptation is out of range
- Waste gate actuator controller adaptation value is lower than -24.8%
- Waste gate actuator controller adaptation value is higher than 24.8%
|
| Diagnostic Time |
|
| MIL On Condition |
|