LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Engine Control System Diagnosis - 3.3L (5 Of 9)) >> DTC P03B9-00: Cylinder 4 Pressure Too High >> Verification of Repair >> Verification of Vehicle Repair

Verification of Vehicle Repair

WARNING: This page is about a different variant/trim than selected.

After a repair, it is essential to verify that the fault has been corrected.

  1. Vehicle Parked & Ignition ON.
  2. After connecting GDS select "Diagnostic Trouble Codes (DTC)  " Analysis mode.
  3. Clear recorded DTC using GDS.
  4. Operate the system within DTC "Enable Conditions" in "General information".
  5. After selecting "Diagnostic Trouble Codes (DTC)  " mode and check if DTC is recorded again.
  6. Are any DTCs recorded?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System is performing to specification at this time.
scientia non olet · About LEMON Manuals