Check open in harness
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect CMPS (B1-Exhaust) connector and ECM connector.
- Measure resistance between signal terminal of CMPS (B1-Exhaust) harness connector and CMPS (B1-Exhaust) signal terminal of ECM harness connector.
Specification: Below 1Ω
- Is the measured resistance within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open in harness. go to "VERIFICATION OF VEHICLE REPAIR " procedure.