LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Engine Control System Diagnosis - 3.3L (5 Of 9)) >> DTC P0365-00: Camshaft Position Sensor B Circuit Malfunction (Bank 1) >> Wiring Inspection >> Signal Circuit Inspection >> Check open in harness

Check open in harness

WARNING: This page is about a different variant/trim than selected.
  1. IG "OFF". Disconnect CMPS #2 connector and ECM connector.
  2. Measure resistance between signal terminal of CMPS #2 harness connector and CMPS #2 signal terminal of the ECM connector.

    Specification:  Approx. 0Ω

  3. Is resistance within the specification?

    YES 

    • Go to next step as below.

    NO 

scientia non olet · About LEMON Manuals