LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Engine Control System Diagnosis - 3.3L (5 Of 9)) >> DTC P0346-00: Camshaft Position Sensor A Circuit Range/Performance (Bank 2) >> Wiring Inspection >> Ground Circuit Inspection >> Check open in harness

Check open in harness

WARNING: This page is about a different variant/trim than selected.
  1. IG "OFF". Disconnect CMPS (B2-Intake) connector and then IG "ON".
  2. Measure voltage between signal terminal of CMPS (B2-Intake) harness connector and chassis ground. (Measurement "A")
  3. Measure voltage between signal and ground terminals of CMPS (B2-Intake) harness connector. (Measurement "B")

    Specification:  Voltage difference between measurement "A" and "B" is below 200 mV.

  4. Is the measured voltage within specification?

    YES 

    NO